#Instal the new for windows Xreveal free#

Open the window and locate the screw hole in each corner. STEP 5: Drive a 2 ¼-inch screw into each corner of the window frame. The shims should hold the window in place but not be so snug that they’ll interfere with the window’s operation. Shim along the sides of the window at the top, bottom, and middle of the window. If the window frame is quite out of level (particularly in older homes), follow the window’s slope to ensure the window doesn’t appear crooked when finished. With the window sashes in the closed and locked position, place shims under the window to lift and level it in the window opening. STEP 4: Use shims to position the window properly. Use a tape measure to check that the reveal is uniform on each side to ensure that the window is centered.

Place the new vinyl replacement window in the opening and center it, leaving some space on either side of the window for shims and insulation. After confirming the fit, remove the window before squeezing a bead of caulk along the inside of the outer window stops. STEP 3: Center the replacement vinyl window in the opening.įirst, test fit the window to ensure that it fits in the opening. If not, it might be necessary to remove the window trim and adjust the actual frame with shims. Use a tape measure to measure from diagonally opposing corners to ensure they’re within ¼ inch of each other. It is important that the frame be level and plumb, but this is not nearly as critical as its being square. For mildew and other dirt and grime, a mildew remover will often be all it takes to clean the frame. With the old window sashes removed, inspect the existing frame for serious imperfections like rot, mold, splitting, or another issue that might require an in-depth solution. STEP 2: Prepare the window frame for vinyl window installation. If the stops aren’t easy to remove, consider using an oscillating multi-tool to cut them off, taking care not to damage the jamb. With the stops removed, pull the window sashes from the window. Leave the outermost stops and windowsill in place. Slide both sashes to their lowest positions for safety’s sake.įrom the inside of the window, use the prybar and hammer to pry the window stops (the thin strips of wood that hold the window sashes in place) from the sides and top of the window. The first step in vinyl window installation is to remove the old window. This is also a good time to remove the vinyl covers that snap into the new windows’ jamb tracks, as this is where the screws to secure each new window will go.

#Instal the new for windows Xreveal free#

Ensure that the windows are in good working order and free from shipping damage or imperfections. Second, be sure to take accurate measurements and order windows that are as close to those measurements as possible.īeyond those important points, it’s a good idea to unbox and inspect each new vinyl window before beginning the project. If the project ends up taking a little longer than expected, cold weather is far more of an issue than warm weather. The first is to plan the project for warmer weather. There are two key considerations that are critical to a successful vinyl window installation. We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to and affiliated sites.